收藏本站
LTM4618
APPLICATIONS INFORMATION
The LTM4618 can be synchronized from 400kHz to 780kHz
with an input clock that has a high level above 2.0V and a
low level below 0.8V. The 400kHz low end operation limit
is put in place to limit inductor ripple current. See the
Typical Applications section for synchronization examples.
The LTM4618 minimum on-time is limited to about 90ns.
Guardband the on-time to 110ns. The on-time can be
calculated as:
V TRACK is the track ramp applied to the slave’s TK/SS
pin. V TRACK has a control range of 0V to 0.8V. When the
master’s output is divided down with the same resistor
values used to set the slave’s output, then the slave will
coincident track with the master until it reaches its ?nal
value. The master will continue to its ?nal value from the
slave’s regulation point.
Ratiometric modes of tracking can be achieved by select-
? ? OUT ?
t ON(MIN) =
1
FREQ
? V ?
? V IN ?
ing different divider resistor values to change the output
tracking ratio. The master output must be greater than the
slave output for the tracking to work. Master and slave
Soft-Start and Tracking
LTM4618 has the ability to either soft-start by itself with a
capacitor or track the output of an external supply. When
the module is con?gured to soft-start by itself, a capacitor
data inputs can be used to implement the correct resistor
values for coincident or ratio tracking.
should be connected to its TK/SS pin. When the module
is in the shutdown state, the TK/SS pin is actively pulled
to ground.
Once the RUN pin voltage is above 1.22V, the module pow-
ers up. Then a soft-start current of 1.3μA starts to charge
its soft-start capacitor. Note that soft-start or tracking is
achieved not by limiting the maximum output current of
V IN
5V
MASTER R1
OUTPUT 60.4k
C IN
R2
28.7k
MODE/PLLIN INTV CC EXTV CC
V IN FREQ
COMP V OUT
LTM4618
TK/SS V FB
RUN PGOOD
SGND PGND
4618 F04
22pF
28.7k
V OUT(SLAVE)
2.5V/6A
C OUT
the controller but by controlling the output ramp voltage
according to the ramp rate on the TK/SS pin. Current
foldback is disabled during this phase to ensure smooth
soft-start or tracking. The soft-start or tracking range is
de?ned as the voltage range from 0V to 0.8V on the TK/SS
pin. The total soft-start time can be calculated as:
Figure 4. Output Voltage Coincident Tracking
MASTER OUTPUT
t SOFT-START
=
0.8V ? C SS
1.3μA
OUTPUT
SLAVE OUTPUT
Output voltage tracking can be programmed externally
using the TK/SS pin. The master voltage is divided down
with an external resistor divider that is the same as the
slave’s feedback divider to implement coincident tracking.
VOLTAGE
The LTM4618 uses an accurate 60.4k resistor internally
for the top feedback resistor. Figure 4 shows an example
TIME
4618 F05
of coincident tracking.
?
V OUT(SLAVE) = ? 1 +
?
R1 ?
? ? V TRACK
R2 ?
Figure 5. Coincident Tracking Characteristics
4618fa
12
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
LTM4619IV#PBF IC SWIT REG BUCK 4A ADJ 144LGA
LTM4627MPY#PBF IC DC/DC UMODULE 15A 133-BGA
LTM4628EV#PBF IC DC/DC UMODULE 16A 144-LGA
LTM8008HV#PBF IC DC/DC UMODULE 16-LGA
LTM8020IV#PBF IC DC/DC UMODULE 200MA 21-LGA
LTM8023MPV#PBF IC BUCK SYNC ADJ 2A 50LGA
LTM8025MPV#PBF IC CONVERTER BUCK 3A ADJ 70LGA
LTM8026MPV#PBF IC UMODULE 36VIN 5A CVCC 81LGA
相关代理商/技术参数
LTM4618IVPBF 制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule Regulator with Tracking and Frequency Synchronization
LTM4618V 制造商:LINER 制造商全称:Linear Technology 功能描述:6A DC/DC μModule Regulator with Tracking and Frequency Synchronization
LTM4619 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual, 26VIN, 4A DC/DC μModule Regulator
LTM4619EV 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual, 26VIN, 4A DC/DC μModule Regulator
LTM4619EV#PBF 功能描述:IC SWIT REG BUCK 4A ADJ 144LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:66V 电压 - 输入（最大）:160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H（116.8mm x 47.2mm x 20.1mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:*
LTM4619EVPBF 制造商:Linear Technology 功能描述:Conv DC-DC Dual-Out Step Down
LTM4619IV 制造商:LINER 制造商全称:Linear Technology 功能描述:Dual, 26VIN, 4A DC/DC μModule Regulator
LTM4619IV#PBF 功能描述:IC SWIT REG BUCK 4A ADJ 144LGA RoHS:是 类别:电源 - 板载 >> DC DC Converters 系列:µModule® 设计资源:VI-200, VI-J00 Design Guide, Appl Manual 标准包装:1 系列:* 类型:隔离 输出数:1 电压 - 输入（最小）:66V 电压 - 输入（最大）:160V Voltage - Output 1:12V Voltage - Output 2:- Voltage - Output 3:- 电流 - 输出（最大）:* 电源（瓦） - 制造商系列:50W 电压 - 隔离:* 特点:* 安装类型:通孔 封装/外壳:9-FinMod 尺寸/尺寸:4.60" L x 1.86" W x 0.79" H（116.8mm x 47.2mm x 20.1mm） 包装:散装 工作温度:-25°C ~ 85°C 效率:* 电源（瓦特）- 最大:*